Coilover Kit MTS Technik for BMW 5 Series / E28

  •  High quality confirmed by a 2-year warranty without a mileage limit.
  •  Suspension components characterized by increased corrosion resistance and made of the highest quality materials.
  •  Specially selected type of thread and a wide range of suspension adjustment allows optimal setting of the car height.
  •  Adjustable Shock Absorbers protected by a double layer of gold zinc and adjustments made of anodized aluminum guaranteeing increased corrosion resistance.
  •  The possibility of additional adjustment not only the height, but also the angle of the wheel position relative to the body.
  •  Coilover Kit includes springs made by Eibach, the world leader in the sports springs industry.
  •  Innovative hexaCOIL spring perch, significantly increasing the comfort of suspension height adjustment.
  •  Additional height adjustment at the bottom mounting, allowing the car's height reduction to be changed, without interfering with the spring operation characteristics.
  •  Pressurized gas presses the hydraulic fluid, eliminating the "foaming" effect of the oil (an undesirable and typical for oil shock absorbers phenomenon), which means higher efficiency for continuous, intensive work.
  •  The use of twin-tube technology guarantees stable shock absorber performance.

    - Part.NO MTSGWBM19

    Axle Load FA:

    930 kg

    Axle Load RA:

    1030 kg

    Lowering FA:

    25-110 mm

    Lowering RA:

    25-90 mm



    BMW 5 Series E28.  518 / 518i / 520i / 525i / 525e / 528e / 535i / 524D / 524TD / M5 (06/1981 – 12/1987) 



    2 Year warranty 



    MTS Technik


    1 - When the adjustable spring seat is set too low according the catalogue, all guarantuees will be withdrawn.

    2 - Front and rear axle height adjustable (threaded shock absorber housing).

    3 - Only for vehicles without NIVO / OEM pneumatic suspension.

    4 - If the vehicle is equipped with a stock sport suspension, the lowering mentioned in this catalogue will be relatively lower.

    5 - Independent height adjustment at the lower brackets on the front dampers.

    6 - Set includes 2x upper "camber plates" on the front axle.

    7 - The installation requires the use of OE front struts - they should be cut and welded as described in the attached manual.

    8- Front shock absorber housing with 55mm diameter.